[ Closed ] X-Life ver 2.2 R1, R2, R3 for X-Plane 10/11 (Page 7 of 8)

Ho bisogno di aiuto per favore. Ho xlife deluxe da mesi e sempre tutto ok. Da oggi non si attiva flight plan Come posso risolvere problema? grazie

Lugano airport (LSZA) from Aerosoft and X-Life delux, two CRJ2 complete blocked runway and traffic!
RWY is 4429 feet/1350 m. This is a little bit to short for CRJ2!
How this deadlock can bi solved?

Hey friend I have a problem, is that I appear airlines around the world except the local country

Hi jar can you tell me how to get orbx Barton to work with xlife or can you get in touch with orbx to  get there products verified please as they have a lot of good airfields comeing for xplane thanks

Crashed after 5 hours flight just before landing BIKF.

Hello X-Life Developer
Since today i got huge frame drops when i start using x-life deluxe. Till yesterday it worked fantastic, but since today, when i check the taskmanager my cpu and gpu ussage is normaly around 50 to 80 percent in use and when i start x-life deluxe traffic my cpu and gpu ussage drops to around 10 to 20 percent in use and the frames in x-plane are half, from 50 to around 22.
Something changed because till now it was running very good. I tried a new install of x-life but the same thing happend.
Sorry for my bad english, but i hope you understand it.
Thanks for checking
Best Tobi

After using X-Life Deluxe for a couple of months now, I noticed that when you're flying between airfields, continental or inter continental, you hardly see any aircraft.
They tend to stick within a X kilometres distance of a airfield.

Is there something to be done about this ?

(It's quit boring when you're the only one over the atlantic ocean)

Version 2.2r3

X-Plane crashed when asking X-Life ATC for a runway change for take-off...

XL: 768 : ---+++--- Pilot: MANCHESTER Delivery, DTB169, Stand 22, B738, with information Echo, QNH1025, request clearance (S:-1)
XL: 768 : inRW=23R
XL: 768 : inSidPoint=SONEX
XL: 768 : ---+++--- ATC: DTB169, MANCHESTER Delivery, Wrong ATIS Information (S:3)
XL: 775 : Autogen flight: A320 FEI
XL: 775 : X-Life check atis info:Departure: EGCC info Foxtrot. RW in use (TO):RW23R RW23L (LDG):RW23R RW23L Trans.Lvl: 5000 ft. // Arrival: EPWA info Foxtrot. RW in use (TO):RW29 RW33 (LDG):RW29 RW33 Trans.Lvl: 6500 ft.
XL: 780 : Autogen flight: BE20 N145LG
XL: 781 : ---+++--- Pilot: MANCHESTER Delivery, DTB169, Stand 22, B738, with information Foxtrot, QNH1025, request clearance (S:-1)
XL: 781 : inRW=23R
XL: 781 : inSidPoint=SONEX
XL: 781 : ---+++--- ATC: Initial Altitude 7000 feet, Squawk 2714 (S:4)
XL: 781 : ---+++--- ATC: DTB169, MANCHESTER Delivery, Cleared to CHOPIN, Runway 23R, via SONE1R departure, (S:4)
XL: 785 : Autogen flight: B733 NAX

Hi,
I have a problem with EIDW airport from Aerosoft. Below you find a link to a short video showing the issue. This plane completely blocks the runway so ATC doesn't allow any aircraft to take off or land. It occurs in both ver v2 and v4. This is very annoying especially when you had a long flight.

https://youtu.be/tOaEs2RMpmc

Thanks, that’s good to know. I had seen the same thing. Will corrrect xlf file and post somewhere

I'm pretty sure that's what that issue might be in regards to class size but not positive. If 16/34 runway is too short at EIDW for class D E or F then just try up to C and see if that makes a difference. The length of runway 16/34 at EIDW is 6,800ft/ 2073 meters. That is the shorter of both runways. 10/28 is 8,652ft/2,637 meters much longer.

Big Thanks. Could you put a link to the file here.