You are not logged in. Please login or register.
JARDesign Group Board → Custom ATC routes for XP Airports → Xlife asking for Transponder setting...
..all the time after lining up the runway.
Situation:
PAJN, rwy 08, IXEG 737, Tower asked for transponder setting 5277 again and again and again, which was set and on TA/RA..
No further ATC flight was possible...
Any help?
Best
Steff
Hello,
it seems that your transponder is in Standby mode, just turn it on and the atc will authorize the take off
..all the time after lining up the runway.
Situation:
PAJN, rwy 08, IXEG 737, Tower asked for transponder setting 5277 again and again and again, which was set and on TA/RA..
No further ATC flight was possible...Any help?
Best
Steff
Don't use the auto selection on the knob of the Transponder, Move the knob to the TA/RA position manually then it should work. 
No solution... see picture, I set TA/RA manually..
Best
Steff
Image upload doesn´t work...
Steff
JARDesign Group Board → Custom ATC routes for XP Airports → Xlife asking for Transponder setting...
Powered by PunBB, supported by Informer Technologies, Inc.