[ Closed ] XP11.50 JD330 v.4.1 (Page 5 of 10)

Happens to me too and when I load the aircraft up, I just get a black screen with the FPS is too low message at the bottom. I hear sounds, but I can't see anything, it's a fully black screen.

Are new cockpit textures planned for the A330?

Hello,

BSS-Sound not works in XP11.50 beta9 Version!

Thanks :-(

1) I had the same issue twice on a flight from EINN to EGLL both times on short final yesterday. The first time made me miss my approach as I was fighting to regain my electrical power.
I had RAT out warning, Emergency GEN Fault light, Navigation displays went down but AtH stayed up as it accepted the TOGA command. AP went down because I pulled up. I had to turn on APU to get most of my power back on.

After a time when stable in my go around procedure everything came back to normal.

Then again in short final same issue. but by clicking on the Nav display I could read the info on the popup. This time I did not touch the stick in reflex and the AP still landed the plane as planned.

I have a no failure on setting and even when resetting them the problem wasn't solved

2 ) Also I noticed that when the Outer wing tanks transfer into the inner wing tanks, the rudder start to flutter until the outer wing tanks reach about 600kgs each. The flutter seems to be timed with the ticking of the fuel gauge.

I use X-plane 11.41 with JARA330 3.3r2

Hi
you should open a ticket on support forum

   http://www.jardesign.org/ticket/kb/index.php

jcdp

Have an issue with latest beta..Error 1114 with plugins...any tip? (never had it with previous versions)

Hello JD330 users.

I'll find General Electric CF6-80E1 Engine Mod for JAR330 1.0.0 and try. It is very nice free modification and very good look engines.
Works fine with 11.50b9 and last update JD330 for this version. Instalation of this MOD is a little complicated, but with included manual no problem. You can look for this MOD and first look on this site:
https://forum.thresholdx.net/files/file … or-jar330/

Darko

Hi

Depends on slope …

jcdp

Hi

When it is flat you need thrust first because of inertia (you need to start moving aircraft) after you can reduce it but not necessarily down to idle .
jcdp

jcdp

usually the a330 can easily taxi on idle...even if its heavy...thats why i asked.
And thanks for your help

When you reach out of activation you just send a message with your purchase reference to JAR for getting a few more without any problem .

jcdp

Hi

Buy the aircraft and you get it

jcdp

PS: you should avoid capital letters ….