Busy Airport: X-Life ATC Routes for EDDV (tdg) v1.0

ATC Routes for Hannover Airport EDDV (freeware scenery by tdg). Spending a lot of time into traffic optimization, and most times it is a great show. But sometimes it seems some planes are getting nuts.

For a good traffic balance I recommend following settings in XL (see notes below):
- "Traffic Density" to 80 percent or lower
- "Airport Gate/Stands busy" to 40 percent or lower
- "Airport Ops Interval" between 2 and 2.5 minutes

Comments are welcome. Also pls post any issue, but read the notes and known issues below first.
 
Features:
=========
- All three runways are in use.
- 7 gate and 22 ramp positions available, also 5 GA positions. Optimized Gate Editor settings, e.g. no conflict with the static planes in this scenery.
- Added additionally stands for more variety.
- Traffic with up to 12 airplanes at same time, mostly Cat B, C and D, but also some Cat A and E aircrafts.

Notes:
======
- Some of the "hold short" positions are set more close to the runways as shown by markings. This belongs to the taxiway design and some limitations of XL.
- A pushback out of Gate Positions 12 and 13 is even hard for a real truck driver but it is too tricky for XL. For this reason both positions are set to "Hangar" in Gate Editor so XL will not use them for traffic.
- Dont set the "Traffic Density" and "Airport Stands Busy" to high values, otherwise the planes are running in conflicts with collisions as a result. Circa 80 percent for the Density and 40 percent for the Stands are fine values for a good show.

Known Issues:
=============
- Even if I declared both taxiways and runways for the appropriate aircraft categories in WED, it seems that XL didnt recognize them. So it can happen that Cat E airplanes are using the southern runway and sometimes planes other then Cat A are landing on the center runway (very rarely but ugly).
- Airplanes using taxiways F, L and M are ignoring traffic on the center runway. Just a part Im still working on.
- When using FMcar it is ignoring other airplanes on its route. Dont know how to solve this.
- Not all small airplanes (Cat A) are using the center runway only as purposed.
- If a large airplane (Cat E) is rolling to position 21A it is colliding with this stupidly parked B747 in front of hangar #1. If you are firm with WED simply remove this static plane.

Tested in X-Plane 10.51 on Win7
(w) 01.05.2017 @ Haddock
